16925-20 Bently Nevada Interconnect Cable

16925-20 | Bently Nevada | Interconnect Cable

Availability: 10 left in stock

The Bently Nevada 16925-20, also cataloged as the 16925 Interconnect Cable, operates as a dedicated hardware component for signal transmission...

SKU: 16925-20

Manufacturer: Bently Nevada
Product No.: 16925-20
Product Type: Interconnect Cables
Product Origin: USA
Payment:T/T, Western Union
Weight: 250g
Shipping port: Xiamen
Warranty: 12 months

Description Reviews

The Bently Nevada 16925-20, also cataloged as the 16925 Interconnect Cable, operates as a dedicated hardware component for signal transmission between monitoring transducers and interface modules within machine protection networks.

Hardware Specifications

Parameter	Specification
Model	16925-20
Brand	Bently Nevada
Origin	USA
Dimensions	20 ft (6.1 m) length
Operating Temp	-40 deg C to +177 deg C (Standard)
Power Consumption	N/A (Passive component)
Cable Type	3-wire Interconnect

Rotor Dynamics and Signal Integrity

The 16925 cable assembly is designed to facilitate the high-frequency signal propagation required for accurate rotor dynamics observation. To ensure data integrity, the physical installation must prioritize the maintenance of the nominal -10 VDC gap voltage target for eddy-current probe interfaces. Any deviation in the impedance of the signal path, caused by damaged insulation or improper shield termination, can introduce artifacts into the vibration waveform. Cross-talk suppression is achieved through the integrated shielding layer; therefore, it is mandatory that the shield be terminated correctly at the instrumentation ground to prevent ground loops that interfere with phase measurement accuracy.

Frequently Asked Questions

Q: Is the 16925 cable assembly compatible with non-Bently Nevada transducers?

A: The 16925 series is factory-calibrated for specific Bently Nevada transducer interfaces. Use with third-party sensors may result in impedance mismatches, impacting the frequency response and signal-to-noise ratio of the monitoring system.

Q: What are the requirements for cable termination?

A: The assembly must be terminated in accordance with the specific monitoring module's terminal block configuration. Ensure all connections are tight to prevent resistive heating and signal fluctuation.

Field Installation Guidelines

Route the cable through dedicated instrumentation pathways, maintaining a minimum 30 cm separation from high-voltage AC lines to prevent induced noise.
Ensure the connector mating faces are clean and moisture-free before joining.
Observe a minimum bend radius of 10 times the cable diameter during installation to prevent damage to the internal conductors and shielding.
Secure the cable using non-conductive cable ties or clips at 1 m intervals to mitigate the effects of machine-induced vibration.

What's clients say about us

Excellent Emergency Support!

Our production line was down due to a faulty Bently Nevada monitor. We found it in stock here and they shipped it via DHL immediately. Back in operation within 48 hours—truly a lifesaver for our plant.

Mark Thompson

Maintenance Manager, USA

Reliable Source for New Spares

Finding brand new, original modules is critical for our safety. This team delivers factory-fresh components with full certification. Their commitment to only selling new products makes them our most trusted partner.

Robert Hoffmann

Engineering Lead, Germany

Top-tier Service and Quality

We have sourced Honeywell and Schneider parts here for two years. Every shipment arrives well-packaged with original factory seals intact. Clear communication and the best lead times in the industry.