The GE Fanuc IC693BEM331 serves as the primary IC693BEM331 Genius Bus Interface utilized to execute logic-to-bus data translation across Series 90-30 platforms.
Hardware Specifications
| Parameter | Specification |
|---|---|
| Model | IC693BEM331 |
| Brand | GE Fanuc Emerson |
| Origin | United States |
| Weight | 0.40 kg (0.88 lbs) |
| Dimensions | Standard single slot width |
| Operating Temp | Industry standard 0 to 60 deg C (ambient) |
| Power Consumption | < 300 mA at 5 VDC |
| Voltage Input | 5 VDC derived from Series 90-30 backplane |
| Module Type | Genius Bus Interface |
| Local Visual Diagnostics | 2 LEDs (OK and COMM OK) |
| Maximum Data Buffer | 128 bytes of incoming and outgoing data |
| Node Support | Up to 31 maximum I/O devices per bus |
| Enclosure Rating | IP20 |
| Host CPU Compatibility | IC693CPU311K, 321K, 331L or later; all versions of IC693CPU313, 323, 340, 341, 350, 351, 352, 360, 363, 364 |
| System Firmware Requirement | Firmware version 5.0 or later |
Profinet / EtherNet/IP Deterministic Networks and I/O Density Scaling
The module bridges legacy Genius networks to higher automation layers by managing physical link mapping directly on the host backplane. This mapping maintains constant backplane bus communication velocity during system expansion. When integrating with Profinet / EtherNet/IP deterministic networks via master gateways, the module regulates up to 128 bytes of deterministic data packets without overloading CPU task schedules. This architecture maintains structured synchronization across extensive I/O density scaling parameters. It also retains total configuration integrity, provided the host processors fulfill explicit firmware flash compatibility limits of version 5.0 or higher.
Frequently Asked Questions
Q: What is the maximum number of IC693BEM331 controllers that can be installed in a single Series 90-30 chassis?
A: A single Series 90-30 PLC system supports up to 8 Genius Bus Controllers or enhanced Genius communications modules simultaneously, provided the host CPU runs firmware version 5.0 or later.
Q: How are visual diagnostics interpreted through the front panel LEDs?
A: The OK LED remains steadily illuminated following the successful execution of power-up diagnostics. The COMM OK LED stays on continuously during active network data transmission and blinks to indicate intermittent connections or line errors.
Field Installation Guidelines
- Isolate all primary power supplies connected to the Series 90-30 baseplate prior to inserting or removing the bus controller module.
- Align the board with the structural card guides of the baseplate slot and seat the module firmly until the rear connector latches with the backplane bus tracks.
- Terminate all Genius network trunk wiring onto the terminal block using high-grade shielded twisted-pair cables to minimize signal attenuation and common-mode noise.
- Ground the communication cable shield directly to the dedicated enclosure ground bar; avoid mixing field network signaling cables with high-voltage AC actuator conduits inside the panel wireways.
What's clients say about us
Excellent Emergency Support!
Our production line was down due to a faulty Bently Nevada monitor. We found it in stock here and they shipped it via DHL immediately. Back in operation within 48 hours—truly a lifesaver for our plant.
Mark Thompson
Maintenance Manager, USAReliable Source for New Spares
Finding brand new, original modules is critical for our safety. This team delivers factory-fresh components with full certification. Their commitment to only selling new products makes them our most trusted partner.
Robert Hoffmann
Engineering Lead, GermanyTop-tier Service and Quality
We have sourced Honeywell and Schneider parts here for two years. Every shipment arrives well-packaged with original factory seals intact. Clear communication and the best lead times in the industry.
Lucas Müller
Operations Director, GermanyRelated Products
Guide
Translation missing: en.general.search.loading