The GE IS220PDIAH1B, also cataloged as the IS220PDIAH1B Discrete Input Pack, operates as a dedicated hardware component for high-density 24 VDC field signal processing within GE Mark VIe and Mark VIeS platforms. Cross-referenced as IS230SNCIH2A, the unit interfaces up to 32 discrete input channels from limit switches, dry contacts, and pushbuttons directly to the IONet control network backbone.
| Parameter | Specification |
|---|---|
| Model | IS220PDIAH1B |
| Brand | GE |
| Origin | USA |
| Weight | 0.9 kg |
| Dimensions | 225 mm x 167 mm x 55 mm |
| Operating Temp | -30 to 65 deg C |
| Power Consumption | 10 W typical (28 VDC nominal input) |
| Channel Count | 32 discrete inputs |
| Input Voltage | 18 to 32 VDC (24 VDC nominal) |
| Input Current | 7 mA per channel typical |
| Response Speed | State change detection within 1 ms or less |
| Galvanic Isolation | 1500 VDC (field-to-logic) |
| Communication | Dual 100 Mbps Ethernet (IONet) |
The IS220PDIAH1B leverages dual 100 Mbps Ethernet IONet architecture to maximize backplane bus communication velocity across Mark VIe control backbones. Integrated firmware flash compatibility enables sub-millisecond state change detection across all 32 channels without latency spikes. Galvanic isolation rated at 1500 VDC suppresses field-side noise interference, preventing transient voltage spikes from disrupting deterministic communication loops or logic processing across redundant I/O network paths.
Q: How does the IS220PDIAH1B maintain network connection redundancy?
A: The module incorporates dual 100 Mbps IONet Ethernet interfaces, providing twin independent communication paths to dual or triple controller configurations.
Q: What input voltage boundaries apply to the 32 discrete channels?
A: Each input accepts a nominal 24 VDC input within an operational range of 18 to 32 VDC, drawing approximately 7 mA per active channel.
Q: Can the IS220PDIAH1B pack be replaced while the control rack is energized?
A: Yes, the I/O pack supports live insertion and removal directly on the compatible terminal board without disrupting adjacent system hardware.
Mount the IS220PDIAH1B assembly onto the matching terminal board via the integrated mounting screws or DIN-rail hardware inside the panel enclosure. Route all 24 VDC discrete signal wiring through dedicated wire ducts, maintaining physical separation from high-voltage AC lines to minimize electromagnetic coupling. Fasten both IONet Ethernet cables into the primary and secondary RJ45 network connectors until the locking tabs snap firmly into place. Connect the cabinet system ground bus to the terminal board grounding pad using a low-impedance conductor to satisfy electromagnetic compatibility requirements.
Our production line was down due to a faulty Bently Nevada monitor. We found it in stock here and they shipped it via DHL immediately. Back in operation within 48 hours—truly a lifesaver for our plant.
Finding brand new, original modules is critical for our safety. This team delivers factory-fresh components with full certification. Their commitment to only selling new products makes them our most trusted partner.
We have sourced Honeywell and Schneider parts here for two years. Every shipment arrives well-packaged with original factory seals intact. Clear communication and the best lead times in the industry.