The Yokogawa SSC10D-S2111, also cataloged as the SSC10D Duplexed Safety Control Unit, operates as a dedicated hardware component for safety logic execution and deterministic response processing within ProSafe-RS platforms.
| Parameter | Specification |
|---|---|
| Model | SSC10D-S2111 |
| Brand | Yokogawa Electric Corporation |
| Origin | Japan |
| Weight | 8.5 kg |
| Dimensions | Standard 19-inch rack mount chassis |
| Operating Temp | -20 deg C to +60 deg C |
| Power Consumption | 200-290 VA (AC variants), 5.5-7.0 A (DC variants) |
| Architecture | 1oo2D duplex redundancy with dual MIPS R5000 processors |
| Memory Capacity | 32 MB main memory with battery-backed NVRAM |
| System Communication | Dual-redundant Vnet/IP, dual ESB bus interfaces |
| Expansion Limit | Supports up to 9 Safety Node Units and 78 I/O modules per SCS |
| Certification | IEC 61508 SIL3, ISA G3 conformal coating compliance |
The SSC10D-S2111 core logic engine processes field input and output data using dual-redundant Vnet/IP interfaces operating at 100 Mbps. Internal backplane isolation circuits enforce strict channel-to-channel isolation between power distribution lines and logic buses. This prevents field voltage transients on 4-20 mA HART loop protocol instruments from compromising dual-processor diagnostic routines or interfering with lockstep execution cycles across the 1oo2D controller architecture.
Q: How does the 1oo2D redundancy structure handle internal diagnostic detection on the SSC10D-S2111?
A: The twin MIPS R5000 CPUs execute identical logic in parallel while internal hardware comparators constantly cross-check execution steps. If one processor reports an internal diagnostic fault, the unit isolates the failed channel and maintains continuous control via the secondary healthy processor.
Q: What battery maintenance cycle applies to the NVRAM data retention circuit?
A: The integrated memory backup battery maintains non-volatile RAM state data during total power outages and requires replacement every 3 years under continuous operation at temperatures below 30 deg C.
Mount the SSC10D-S2111 unit securely inside a standard 19-inch instrument rack using M5 panel mounting screws. Connect the dual Vnet/IP network channels using separate, path-redundant Category 5e shielded cables to reduce the risk of simultaneous physical cable cuts. Establish low-impedance frame grounding by bonding the chassis grounding stud directly to the main cabinet ground bar. Maintain adequate thermal clearance around cabinet intake vents when operating in ambient temperatures above 50 deg C to allow internal cooling fans to maintain proper heat dissipation.
Our production line was down due to a faulty Bently Nevada monitor. We found it in stock here and they shipped it via DHL immediately. Back in operation within 48 hours—truly a lifesaver for our plant.
Finding brand new, original modules is critical for our safety. This team delivers factory-fresh components with full certification. Their commitment to only selling new products makes them our most trusted partner.
We have sourced Honeywell and Schneider parts here for two years. Every shipment arrives well-packaged with original factory seals intact. Clear communication and the best lead times in the industry.